REMOVAL
Removal / installation · Vehicles built from Jan 2007
Versions by build date: Nov 2005 – Dec 2006 from Jan 2007
| 1.
REMOVE REAR SEAT LEG COVER |
|
| 2.
REMOVE REAR NO. 2 SEAT LEG SIDE COVER |
|
| 3.
REMOVE REAR NO. 3 SEAT LEG SIDE COVER
|
 |
Using a screwdriver, detach the 4 claws and remove the side cover.
- HINT:
- Tape the screwdriver tip before use.
| 4.
REMOVE REAR NO. 4 SEAT LEG SIDE COVER |
|
| 5.
REMOVE REAR NO. 5 SEAT LEG SIDE COVER |
|
| 6.
REMOVE REAR SEAT LAP TYPE BELT ASSEMBLY CENTER RH |
 |
Remove the bolt and the seat belt.
| 7.
REMOVE REAR NO. 1 SEAT ASSEMBLY LH
|
 |
Lift up the seat track adjusting handle and move the seat to the rearmost position.
- Remove the 2 bolts on the front side of the seat.
Lift up the seat track adjusting handle and move the seat to the foremost position.
- Remove the 3 bolts on the rear side of the seat.
Fully tilt the seatback forward. Then remove the seat.
- NOTICE:
- Be careful not to damage the vehicle body,
| 8.
REMOVE REAR SEAT REAR BRACKET COVER LH
|
 |
- Open the lower part of the seatback cover. Then remove the 2 screws.
Using a screwdriver, detach the 4 clips and remove the bracket cover.
| 9.
REMOVE REAR SEAT LAP TYPE BELT ASSEMBLY CENTER LH |
 |
Remove the bolt and the seat belt.
| 10.
REMOVE REAR SEAT INNER BELT ASSEMBLY RH (for 60/40 Split Seat Type LH Side) |
 |
Remove the bolt and the seat belt.
| 11.
REMOVE REAR NO. 1 SEAT ASSEMBLY RH
|
 |
Lift up the seat track adjusting handle and move the seat to the rearmost position.
- Remove the 2 bolts on the front side of the seat.
Lift up the seat track adjusting handle and move the seat to the foremost position.
- Remove the 3 bolts on the rear side of the seat.
Fully tilt the seatback forward. Then remove the seat.
- NOTICE:
- Be careful not to damage the vehicle body,
| 12.
REMOVE REAR SEAT INNER BELT ASSEMBLY RH (for 60/40 Split Seat Type RH Side) |
 |
Remove the bolt and the seat belt.