INSTALLATION
Removal / installation · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007
- NOTICE:
- When the 4WD control ECU is replaced with a normal one from another vehicle, perform calibration (Click here). If the 4WD control ECU is replaced with a new one, calibration is unneccessary.
- HINT:
- Calibrate the 4WD control ECU by performing calibration of the vehicle stability control system.
| 1. INSTALL 4WD CONTROL ECU |
![]() ![]() |
Install the ECU with the bolt.
- Torque:
- 4.5 N*m{ 46 kgf*cm , 40 in.*lbf }
Connect the connector.
| 2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY (for LHD) |
![]() ![]() |
Attach the 2 hinges to install the door.
Attach the claw to the glove compartment door stopper.

While pushing in the sides of the glove compartment door as indicated by the arrows in the illustration, close the door to engage it to the 2 stoppers.
| 3. INSTALL LOWER INSTRUMENT FINISH PANEL (for RHD) |
![]() ![]() |
Attach the 8 claws to install the lower instrument panel finish panel.
Install the 2 screws.
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |



