2005-2008 RAV4 · Service Manual DRIVE LINE

REMOVAL

Removal / installation · Vehicles built from Jan 2007

Versions by build date: Nov 2005 – Dec 2006 from Jan 2007


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY (for LHD)

B129889E01
  1. Open the glove compartment door.

  1. Detach the claw from the glove compartment door stopper.

  1. While pushing in the sides of the glove compartment door as indicated by the arrows in the illustration, open the door to release it from the 2 stoppers.

  1. B129888
    Open the door until it is horizontal.

  1. B129888
    Pull the glove compartment door toward the rear of the vehicle to detach the 2 hinges and remove the glove compartment door.


3. REMOVE LOWER INSTRUMENT FINISH PANEL (for RHD)

B132919
  1. Remove the 2 screws.

  1. Using a screwdriver, detach the 8 claws and remove the lower instrument panel finish panel.

    HINT:
    Tape the screwdriver tip before use.


4. REMOVE 4WD CONTROL ECU

C129216
  1. Disconnect the connector.

  1. Remove the bolt and ECU.

← REMOVAL (Nov 2005 – Dec 2006)INSTALLATION (Nov 2005 – Dec 2006) →