2005-2008 RAV4 · Service Manual BODY ELECTRICAL

Entry Functions do not Operate at All

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

When the entry functions do not operate at all, it is possible that the certification ECU is malfunctioning or that the wire harness leading to the certification ECU is short circuited.

WIRING DIAGRAM

B133570E01

INSPECTION PROCEDURE


1. CHECK KEY CANCEL FUNCTION
  1. Check that the key cancel function has been set (Click here).

    OK:
    Key cancel function is set.



OK
END (UNSET KEY CANCEL FUNCTION)
NG


2. CHECK WIRE HARNESS (CERTIFICATION ECU - BATTERY AND BODY GROUND)
B107456E37
  1. Disconnect the E63 ECU connector.

  1. Measure the resistance and voltage of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E63-17 (E) - Body ground
    Below 1 Ω

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E63-18 (IG) - Body ground
    Ignition switch on (IG)
    10 to 14 V
    Ignition switch off
    Below 1 V
    E63-1 (+B1) - Body ground
    Always
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE ECU AGGREGATION BOX (CERTIFICATION ECU)


← Entry Interior Alarm does not Sound (from Nov 2005)Back Door Entry Unlock Function does not Operate (from Nov 2005) →