2005-2008 RAV4 · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Aug 2007


1. INSTALL TIMING CHAIN CASE OIL SEAL
  1. Apply MP grease to a new oil seal lip.

  1. A124982E01
    Using SST and a hammer, tap in the oil seal until its surface is flush with the timing chain cover edge.
    SST
    09223-22010  
    09506-35010  

    NOTICE:
    1. Keep the lip free of foreign matter.
    2. Do not tap the oil seal at an angle.


2. INSTALL CRANKSHAFT PULLEY

  1. A132068E01
    Align the pulley set key with the key groove of the pulley, and slide on the pulley.

  1. Using SST, install the pulley bolt.

    SST
    09213-70011   (09213-70020)
    09330-00021  

    Torque:
    250 N*m{ 2549 kgf*cm , 184 ft.*lbf }


3. INSTALL V-RIBBED BELT

  1. A137895
    Rotate the tensioner pulley counterclockwise, and then install the V-ribbed belt.

  1. A139509E01
    If it is difficult to install the V-ribbed belt, perform the following procedure.

    1. Put the V-ribbed belt on everything except the tensioner pulley as shown in the illustration.

    2. While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the tensioner pulley.

      NOTICE:
      1. Put the backside of the V-ribbed belt on the tensioner pulley and idler pulley.
      2. Check that the V-ribbed belt is properly set to each pulley.


4. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH

  1. A129514E01
    Install the reinforcement with the 4 bolts.

    Torque:
    96 N*m{ 978 kgf*cm , 71 ft.*lbf }


5. INSTALL REAR ENGINE UNDER COVER RH
  1. Install the under cover with the 2 clips.


6. INSTALL NO. 1 ENGINE UNDER COVER
  1. Install the under cover with the 2 bolts, 4 screw and 12 clips.


7. INSTALL FRONT WHEEL RH

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }


8. CONNECT RADIATOR RESERVOIR TANK ASSEMBLY

  1. A178054
    Connect the reservoir tank with the 2 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }


9. INSTALL V-BANK COVER SUB-ASSEMBLY

  1. A137900
    Attach the 3 clips to install the engine cover.


10. INSTALL RADIATOR SUPPORT OPENING COVER

  1. A137899
    Install the cover with the 9 clips.

← REMOVAL (from Aug 2007)COMPONENTS (from Aug 2007) →