2005-2008 RAV4 · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Aug 2007


1. REMOVE RADIATOR SUPPORT OPENING COVER

  1. A137899
    Remove the 9 clips and cover.


2. REMOVE V-BANK COVER SUB-ASSEMBLY

  1. A137900
    Detach the 3 clips and remove the V-bank cover.


3. DISCONNECT RADIATOR RESERVOIR TANK ASSEMBLY

  1. A178054
    Remove the 2 bolts and disconnect the reservoir tank.


4. REMOVE FRONT WHEEL RH

5. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 2 bolts, 4 screw, 10 clips and under cover.


6. REMOVE REAR ENGINE UNDER COVER RH
  1. Remove the 2 clips and under cover.


7. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH

  1. A129514E01
    Remove the 4 bolts and reinforcement.


8. REMOVE V-RIBBED BELT

  1. A137895
    Rotate the tensioner pulley counterclockwise to loosen the belt tension. Then remove the V-ribbed belt.

  1. A095070E01
    While turning the belt tensioner counterclockwise, align its holes, and then insert a 5 mm bi-hexagon wrench into the holes to fix the V-ribbed belt tensioner in place.


9. REMOVE CRANKSHAFT PULLEY

  1. A132066E01
    Using SST, loosen the crankshaft pulley set bolt.
    SST
    09213-70011   (09213-70020)
    09330-00021  

  1. A132067E01
    Using the pulley set bolt and SST, remove the crankshaft pulley.
    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)


10. REMOVE TIMING CHAIN CASE OIL SEAL

  1. A132241E01
    Using a knife, cut off the oil seal lip.

  1. Using a screwdriver, pry out the oil seal.

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.

← COMPONENTS (from Aug 2007)INSTALLATION (from Aug 2007) →