2005-2008 RAV4 · Service Manual DRIVE LINE

REMOVAL

Removal / installation · Vehicles built from Nov 2005


1. REMOVE PROPELLER SHAFT WITH CENTER BEARING SHAFT ASSEMBLY

  1. C127524
    Remove the 2 bolts and 2 adjusting washers, and disconnect the propeller with center bearing shaft.

    NOTICE:
    1. During the removal, do not exert excessive force on the universal joint.
    2. When removing, transporting or storing the propeller with center bearing shaft assembly, do not allow the No. 2 joint angle to exceed 20°.

  1. C127525E01
    Place matchmarks on the differential carrier and propeller shaft.

  1. Remove the 4 nuts and 4 washers, and disconnect the propeller shaft and differential carrier.

  1. C127526E01
    Place matchmarks on the transfer and propeller shaft.

  1. Remove the 4 nuts and 4 washers, and disconnect the propeller shaft from the transfer.

← COMPONENTS (from Nov 2005)INSPECTION (from Nov 2005) →