Remove the drain plug and gasket, and drain the oil.
Install a new gasket and the drain plug.
Torque:
49 N*m{
500 kgf*cm
, 36 ft.*lbf
}
4.
REMOVE FRONT AXLE HUB NUT
Using SST and a hammer, unstake the staked part of the nut.
SST
09930-00010
NOTICE:
Loosen the staked part of the nut completely, otherwise the screw of the drive shaft may be damaged.
While applying the brakes, remove the lock axle hub nut.
5.
REMOVE FRONT SPEED SENSOR LH
Disconnect the sensor connector.
Remove the sensor clip (labeled A), bolt (labeled B) and sensor clamp (labeled C).
Remove the sensor clip (labeled D), bolt (labeled E) and sensor clamp (labeled F).
Remove the bolt and sensor body from the knuckle.
NOTICE:
Keep the sensor tip and sensor installation hole free from foreign matter.
6.
REMOVE FRONT SPEED SENSOR RH
HINT:
Use the same procedures described for the LH side.
7.
DISCONNECT FRONT DISC BRAKE CYLINDER ASSEMBLY LH
Remove the 2 bolts and cylinder.
8.
DISCONNECT FRONT DISC BRAKE CYLINDER ASSEMBLY RH
HINT:
Use the same procedures described for the LH side.
9.
REMOVE FRONT STABILIZER LINK ASSEMBLY LH
Remove the 2 nuts and stabilizer link.
10.
REMOVE FRONT STABILIZER LINK ASSEMBLY RH
HINT:
Use the same procedures described for the LH side.
11.
DISCONNECT FRONT SUSPENSION LOWER NO. 1 ARM SUB-ASSEMBLY LH
Remove the bolt and 2 nuts.
Disconnect the lower arm from the ball joint.
12.
DISCONNECT FRONT SUSPENSION LOWER NO. 1 ARM SUB-ASSEMBLY RH
HINT:
Use the same procedures described for the LH side.
13.
DISCONNECT STEERING KNUCKLE WITH AXLE HUB LH
Put matchmarks on the drive shaft and axle hub.
NOTICE:
Do not punch the marks.
Using a plastic-faced hammer, disconnect the steering knuckle with axle hub.
NOTICE:
Be careful not to damage the boot and speed sensor rotor.
Do not excessively push out the drive shaft from the axle assembly.
14.
DISCONNECT STEERING KNUCKLE WITH AXLE HUB RH
15.
DISCONNECT TIE ROD END SUB-ASSEMBLY LH
Remove the cotter pin and castle nut.
Using SST, disconnect the tie rod end from the steering knuckle.
NOTICE:
Do not damage the tie rod end dust cover.
SST
09628-62011
16.
DISCONNECT TIE ROD END SUB-ASSEMBLY RH
HINT:
Use the same procedures described for the LH side.
17.
REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
Using SST, remove the front drive shaft.
SST
09520-01010 09520-24010
(09520-32040)
NOTICE:
Be careful not to damage the transaxle case oil seal, inboard joint boot and drive shaft dust cover.
Be careful not to drop the drive shaft.
18.
REMOVE FRONT DRIVE SHAFT ASSEMBLY RH
Remove the 2 bolts and pull out the drive shaft together with the drive shaft bearing case.
Remove the drive shaft from the transaxle.
NOTICE:
Be careful not to damage the inboard joint boot and drive shaft dust cover.
Be careful not to drop the drive shaft.
19.
FIX FRONT AXLE ASSEMBLY
NOTICE:
The hub bearing could be damaged if it is subjected to the vehicle weight, such as when moving the vehicle with the drive shaft removed. Therefore, if it is absolutely necessary to place the vehicle weight on the hub bearing, first support it with SST.