2005-2008 RAV4 · Service Manual DRIVE LINE

REASSEMBLY

Removal / installation · Vehicles built from Nov 2005

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. INSTALL REAR DRIVE SHAFT DUST COVER LH

C129497E01
  1. Using SST and a press, press in a new drive shaft dust cover.

    SST
    09527-10011  

    NOTICE:
    1. The dust cover should be installed completely.
    2. Be careful not to damage the dust cover.


2. INSTALL REAR DRIVE SHAFT INBOARD JOINT SHAFT SNAP RING LH
  1. Install a new hole snap ring.


3. INSTALL REAR DRIVE SHAFT INBOARD JOINT ASSEMBLY LH
  1. Wrap the spline of the outboard joint shaft with vinyl tape to prevent the boots from being damaged.

  1. Install new parts to the outboard joint shaft in the following order.

    1. Inboard joint boot clamp

    2. No. 2 inboard joint boot clamp

    3. Inboard joint boot

  1. Place the beveled side of the tripod axial spline toward the outboard joint.

  1. Align the matchmarks placed before removal.

  1. C129498
    Using a brass bar and hammer, tap the tripod joint onto the drive shaft.

    NOTICE:
    1. Do not tap the rollers.
    2. Be sure to install the tripod joint in the correct direction.

  1. Pack the inboard joint shaft and boot with grease from the boot kit.

    Standard grease capacity:
    86 to 96 g (3.0 to 3.4 oz.)

  1. C129499
    Using a snap ring expander, install a new shaft snap ring.

  1. Align the matchmarks, and install the inboard joint to the outboard joint shaft.


4. INSTALL REAR AXLE INBOARD JOINT BOOT
  1. Install the inboard joint boot to the inboard joint.


5. INSTALL REAR DRIVE SHAFT INBOARD JOINT BOOT NO. 2 CLAMP LH

C129501E01
  1. Using needle-nose pliers, install the No. 2 inboard joint boot clamp, as shown in the illustration.

    NOTICE:
    Be careful not to damage the boot.


6. INSTALL REAR DRIVE SHAFT INBOARD JOINT BOOT CLAMP LH

  1. C129502E01
    Using a screwdriver, install the inboard joint boot clamp, as shown in the illustration.

    NOTICE:
    Be careful not to damage the boot.


7. INSPECT REAR DRIVE SHAFT

C129503
  1. Check that there is no severe play in the radial direction of the outboard joint.

  1. Check that the inboard joint slides smoothly in the thrust direction.

  1. Check that there is no severe play in the radial direction of the inboard joint.

  1. C127699E01
    Check the boots for damage.

    NOTICE:
    Keep the drive shaft assembly level during inspection.

    HINT:
    For dimension (A), refer to the following values.

    Reference value:
    733.8 mm (28.890 in.)

← DISASSEMBLY (from Nov 2005)INSTALLATION (Nov 2005 – Dec 2006) →