2005-2008 RAV4 · Service Manual DRIVE LINE

DISASSEMBLY

Removal / installation · Vehicles built from Nov 2005

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. REMOVE REAR DRIVE SHAFT INBOARD JOINT BOOT NO. 2 CLAMP LH

C129490E01
  1. Using needle-nose pliers, remove the No. 2 inboard joint boot clamp, as shown in the illustration.


2. REMOVE REAR DRIVE SHAFT INBOARD JOINT BOOT CLAMP LH

C129491
  1. Using a screwdriver, remove the inboard joint boot clamp, as shown in the illustration.


3. REMOVE REAR AXLE INBOARD JOINT BOOT
  1. Remove the boot from the inboard joint.


4. REMOVE REAR DRIVE SHAFT INBOARD JOINT ASSEMBLY LH

C129505E01
  1. Remove any old grease from the inboard joint.

  1. Put matchmarks on the inboard joint and outboard joint shaft.

    NOTICE:
    Do not punch the marks.

  1. Remove the inboard joint from the outboard joint shaft.

  1. C129493
    Using a snap ring expander, remove the shaft snap ring.

  1. C129492E01
    Put matchmarks on the outboard joint shaft and tripod joint.

    NOTICE:
    Do not punch the marks.

  1. Using a brass bar and hammer, tap out the tripod joint from the outboard joint shaft.

    NOTICE:
    Do not tap the rollers.

  1. Remove the inboard joint boot.


5. REMOVE REAR DRIVE SHAFT INBOARD JOINT LH SHAFT SNAP RING

C129495
  1. Using a screwdriver, remove the hole snap ring.


6. REMOVE REAR DRIVE SHAFT DUST COVER LH

C129496E01
  1. Using SST and a press, press out the shaft dust cover.

    SST
    09950-00020  

    NOTICE:
    Be careful not to drop the inboard joint.

← REMOVAL (from Aug 2007)REASSEMBLY (from Nov 2005) →