2005-2008 RAV4 · Service Manual DRIVE LINE

REMOVAL

Removal / installation · Vehicles built from Nov 2005


1. DRAIN DIFFERENTIAL OIL

  1. C109019
    Using a 10 mm socket hexagon wrench, remove the rear differential drain plug and gasket, and drain the oil.

  1. Install a new gasket to the rear differential drain plug.

  1. Using a 10 mm socket hexagon wrench, install the rear differential drain plug and gasket.


2. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

  1. C127524
    Remove the 2 bolts and 2 adjusting washers, and disconnect the propeller with center bearing shaft.

    NOTICE:
    1. During the removal, do not exert excessive force on the universal joint.
    2. When removing, transporting or storing the propeller with center bearing shaft assembly, do not allow the No. 2 joint angle to exceed 20°.

  1. C127525E01
    Place matchmarks on the differential carrier and propeller shaft.

  1. Remove the 4 nuts and 4 washers, and disconnect the propeller shaft and differential carrier.

  1. C127526E01
    Place matchmarks on the transfer and propeller shaft.

  1. Remove the 4 nuts and 4 washers, and disconnect the propeller shaft from the transfer.


3. REMOVE ELECTROMAGNETIC COUPLING

C110131E01
  1. Install a dial gauge so that it is perpendicular to the inner side of the transmission coupling.

  1. Using SST, rotate the transmission coupling assembly forward and backward and measure the vertical runout.

    SST
    09564-32011  

    Maximum vertical runout:
    0.06 mm (0.0023 in.)

  1. Install a dial gauge perpendicularly onto the transmission coupling assembly, as shown in the illustration.

  1. Using SST, rotate the transmission coupling assembly forward and backward and measure the lateral runout.

    SST
    09564-32011  

    Maximum lateral runout:
    0.07 mm (0.0027 in.)


4. REMOVE 4WD LINEAR SOLENOID

C129932
  1. Using a snap ring expander, remove the snap ring.

  1. C129931
    Remove the solenoid from the yoke.

  1. Remove the O-ring from the solenoid.


5. REMOVE YOKE

C129930
  1. Using a 5 mm socket hexagon wrench, remove the 3 bolts and yoke from the differential carrier.


6. REMOVE TRANSMISSION COUPLING CONICAL SPRING WASHER

  1. C109021E01
    Remove the spring washer from the differential carrier.


7. REMOVE TRANSMISSION COUPLING SHIM

  1. C109022E01
    Remove the shim from the differential carrier.


8. REMOVE DIAPHRAGM OIL SEAL

  1. C109023E01
    Using SST, remove the oil seal from the rear differential carrier.
    SST
    09308-10010  

← COMPONENTS (from Nov 2005)INSTALLATION (from Nov 2005) →