ON-VEHICLE INSPECTION
Inspection · Vehicles built from Nov 2005
| CHECK FRONT AXLE HUB BEARING |
![]() ![]() |
Remove the front wheel.
Disconnect the front disc brake cylinder (Click here).
Remove the front disc.
Inspect the axle hub backlash.
Using a dial indicator, measure the backlash near the center of the axle hub.
- Maximum backlash:
- 0.05 mm (0.0020 in.)
- If the backlash is greater than the maximum, replace the bearing.
Inspect the axle hub deviation.
Using a dial indicator, measure the deviation on the surface of the axle hub.
- Maximum deviation:
- 0.05 mm (0.0020 in.)
- If the deviation is greater than the maximum, replace the bearing.


