4.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
5.
REMOVE FRONT AXLE SHAFT LH NUT
Using SST and a hammer, unstake the staked part of the nut.
SST
09930-00010
NOTICE:
Loosen the staked part of the nut completely, otherwise the screw of the drive shaft may be damaged.
While applying the brakes, remove the lock axle hub nut.
6.
REMOVE FRONT SPEED SENSOR LH
Disconnect the sensor connector.
Remove the sensor clip (labeled A), bolt (labeled B) and sensor clamp (labeled C).
Remove the sensor clip (labeled D), bolt (labeled E) and sensor clamp (labeled F).
Remove the bolt and sensor body from the knuckle.
NOTICE:
Keep the sensor tip and sensor installation hole free from foreign matter.
7.
REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY LH
Remove the 2 bolts and cylinder.
8.
REMOVE FRONT DISC
Put matchmarks on the disc and axle hub.
Remove the disc.
9.
DISCONNECT TIE ROD END SUB-ASSEMBLY LH
Remove the cotter pin and castle nut.
Using SST, disconnect the tie rod end from the steering knuckle.
NOTICE:
Do not damage the tie rod end dust cover.
SST
09628-62011
10.
DISCONNECT FRONT SUSPENSION NO. 1 LOWER ARM SUB-ASSEMBLY LH
Remove the bolt and 2 nuts.
Disconnect the lower arm from the ball joint.
11.
REMOVE STEERING KNUCKLE WITH AXLE HUB
Remove the 2 bolts and 2 nuts, and disconnect the shock absorber from the steering knuckle.
HINT:
While fixing the nuts in place, loosen and remove the bolts.
Put matchmarks on the drive shaft and the axle hub.
Using a plastic-faced hammer, remove the steering knuckle with axle hub.
NOTICE:
Be careful not to damage the boot and speed sensor rotor. Do not excessively push out the drive shaft from the axle assembly.
12.
REMOVE FRONT LOWER BALL JOINT ASSEMBLY LH
Remove the cotter pin and nut.
Using SST, remove the lower ball joint.
SST
09628-62011
13.
REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH
Remove the 4 bolts and axle hub from the steering knuckle.
NOTICE:
Do not place the hub and bearing's magnet rotor side so that it is facing downward, and do not allow the magnet rotor side to become damaged or contact foreign matter.