2005-2008 RAV4 · Service Manual SUSPENSION & AXLE

ON-VEHICLE INSPECTION

Inspection · Vehicles built Nov 2005 – Jul 2007

Versions by build date: Nov 2005 – Jul 2007 from Aug 2007


REMOVE REAR WHEEL

REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY LH

C127286
  1. Remove the 2 bolts and cylinder.


REMOVE REAR DISC

  1. C129072E01
    Put matchmarks on the disc and axle hub.

  1. Release the parking brake.

  1. C127304
    Turn the shoe adjuster until the disc turns freely, and then remove the disc.

  1. Install the shoe adjusting hole plug to the rear disc.


CHECK BEARING BACKLASH AND AXLE HUB DEVIATION

  1. C127564E01
    Using a dial indicator, measure the backlash near the center of the axle hub.

    Maximum backlash:
    0.05 mm (0.0020 in.)

    If the backlash is greater than the maximum, replace the axle hub.

  1. Using a dial indicator, measure the deviation on the surface of the axle hub outside the hub bolt.

    Maximum deviation:
    0.08 mm (0.0031 in.) for 2WD
    0.06 mm (0.0024 in.) for 4WD

    If the deviation is greater than the maximum, replace the axle hub.

← COMPONENTS (from Nov 2005)ON-VEHICLE INSPECTION (from Aug 2007) →