ON-VEHICLE INSPECTION
Inspection · Vehicles built from Aug 2007
Versions by build date: Nov 2005 – Jul 2007 from Aug 2007
| REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY LH
|
 |
Remove the 2 bolts and cylinder.
| REMOVE REAR DISC
|
 |
- Put matchmarks on the disc and axle hub.
Release the parking brake.
- Turn the shoe adjuster until the disc turns freely, and then remove the disc.
Install the shoe adjusting hole plug to the rear disc.
| CHECK BEARING BACKLASH AND AXLE HUB DEVIATION |
 |
- Using a dial indicator, measure the backlash near the center of the axle hub.
- Maximum backlash:
- 0.05 mm (0.0020 in.)
If the backlash is greater than the maximum, replace the axle hub.
Using a dial indicator, measure the deviation on the surface of the axle hub outside the hub bolt.
- Maximum deviation:
- 0.08 mm (0.0031 in.) for 2WD
- 0.06 mm (0.0024 in.) for 4WD
If the deviation is greater than the maximum, replace the axle hub.