REMOVAL
Removal / installation · Vehicles built from Nov 2005
- HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- Use the same procedures for the RH side and LH side.
| 1. REMOVE FRONT WHEEL |
| 2. REMOVE FRONT SPEED SENSOR LH |
Disconnect the sensor connector.

Remove the sensor clip (labeled A), bolt (labeled B) and sensor clamp (labeled C).

Remove the sensor clip (labeled D), bolt (labeled E) and sensor clamp (labeled F).


Remove the bolt and sensor body from the knuckle.

- NOTICE:
- Keep the sensor tip and sensor installation hole free from foreign matter.
| 3. REMOVE FRONT STABILIZER LINK ASSEMBLY LH |
Remove the 2 nuts and stabilizer link.

| 4. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING LH |
Remove the 2 bolts and 2 nuts, and disconnect the shock absorber from the steering knuckle.

- HINT:
- While fixing the nuts in place, loosen and remove the bolts.
Remove the 3 nuts and shock absorber with coil spring.

