2005-2008 RAV4 · Service Manual SUSPENSION & AXLE

DISASSEMBLY

Removal / installation · Vehicles built from Nov 2005

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. REMOVE FRONT SUSPENSION SUPPORT PLATE LH
  1. Remove the plate from the shock absorber.


2. REMOVE FRONT SUSPENSION SUPPORT DUST COVER LH
  1. Using a screwdriver, remove the dust cover from the suspension support.

    HINT:
    Tape the screwdriver tip before use.


3. REMOVE FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT

  1. C127543E01
    Install 2 nuts and 2 bolts to the bracket at the lower portion of the shock absorber and secure it with a vise.

  1. Using SST, compress the coil spring.

    SST
    09727-30021   (09727-00010, 09727-00021, 09727-00031)

    HINT:
    To prevent the coil spring from being damaged, wind vinyl tape on the coil spring.

    NOTICE:
    1. When holding the shock absorber with the coil spring removed, do not hold it by the spring lower seat. Also, do not knock the spring lower seat.
    2. Do not use an impact wrench which will damage SST.

  1. C127544E01
    Using SST to hold the spring upper seat, remove the nut.
    SST
    09729-22031  


4. REMOVE FRONT SUSPENSION SUPPORT SUB-ASSEMBLY LH
  1. Remove the suspension support from the shock absorber.


5. REMOVE FRONT SUSPENSION SUPPORT LH DUST SEAL
  1. Remove the dust seal from the shock absorber.


6. REMOVE FRONT COIL SPRING SEAT UPPER LH
  1. Remove the seat upper from the shock absorber.


7. REMOVE FRONT COIL SPRING INSULATOR UPPER LH
  1. Remove the insulator upper from the shock absorber.


8. REMOVE FRONT SPRING BUMPER LH
  1. Disengage the spring bumper from the spring seat.


9. REMOVE FRONT COIL SPRING LH
  1. Remove the coil spring from the shock absorber.

  1. Remove SST from the coil spring.


10. REMOVE FRONT COIL SPRING INSULATOR LOWER LH
  1. Remove the insulator lower from the shock absorber.

← REMOVAL (from Nov 2005)INSPECTION (from Nov 2005) →