REMOVAL
Removal / installation · Vehicles built from Nov 2005
- HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- Use the same procedures for the RH side and LH side.
| 1. REMOVE REAR WHEEL |
| 2. REMOVE REAR NO. 1 SUSPENSION ARM ASSEMBLY LH |
Support the No. 2 suspension arm LH.

Remove the bolt and 2 nuts from the suspension member and axle carrier.

- HINT:
- While fixing the nut in place, loosen and remove the bolt from the suspension member side.
Using SST, disconnect the suspension arm from the axle carrier.
- SST
- 09610-20012
- NOTICE:
- Do not damage the dust cover.
