2005-2008 RAV4 · Service Manual SUSPENSION & AXLE

INSPECTION

Inspection · Vehicles built from Nov 2005


INSPECT REAR NO. 1 SUSPENSION ARM ASSEMBLY LH

C129651
  1. As shown in the illustration, move the ball joint stud back and forth 5 times before installing the nut.

  1. Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and take the torque reading on the fifth turn.

    Standard turning torque:
    3.4 N*m (35 kgf*cm, 30 in.*lbf)

  1. Check for any cracks and grease leaks on the ball joint dust cover.

← REMOVAL (from Nov 2005)INSTALLATION (Nov 2005 – Jul 2007) →