REMOVAL
Removal / installation · Vehicles built from Aug 2007
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007
- HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- Use the same procedures for the RH side and LH side.
| 1. REMOVE REAR WHEEL |
| 2. DISCONNECT NO. 2 PARKING BRAKE CABLE ASSEMBLY |


Remove the cable clamp (labeled A) from the body.
Remove the casing cap bolt (labeled B) from the body.
Remove the clamp bolt (labeled C) from the body.
Remove the clamp bolt (labeled D) from the crossmember.
Remove the clamp bolt (labeled E) from the rear suspension crossmember.
Remove the clamp bolt (labeled F) from the trailing arm.
Disconnect the cable from the parking brake shoe lever and backing plate.
Disconnect the cable from the lever (Click here).
Remove the bolt and disconnect the cable from the backing plate.
| 3. REMOVE REAR TRAILING ARM ASSEMBLY LH |
Remove the 3 bolts, nut and trailing arm from the axle carrier and suspension arm bracket.

- HINT:
- While fixing the nut in place, loosen and remove the bolt.
