REMOVAL
Removal / installation · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006 from Jan 2007
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2.
REMOVE NO. 1 CONSOLE UPPER PANEL GARNISH
|
 |
Using a screwdriver, detach the 4 clips and upper panel garnish.
- HINT:
- Tape the screwdriver tip before use.
| 3.
REMOVE NO. 2 CONSOLE UPPER PANEL GARNISH
|
 |
Using a screwdriver, detach the 4 clips and upper panel garnish.
- HINT:
- Tape the screwdriver tip before use.
| 4.
REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY |
|
| 5.
REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
|
 |
Remove the shift lever knob.
for Manual Transaxle:
Using a screwdriver, detach the 2 clips, 4 claws and remove the upper console panel.
- HINT:
- Tape the screwdriver tip before use.
for Automatic Transaxle:
Using a screwdriver, detach the 2 clips, 4 claws and remove the upper console panel then disconnect the connector.
- HINT:
- Tape the screwdriver tip before use.
| 6.
REMOVE UPPER REAR CONSOLE PANEL SUB-ASSEMBLY
|
 |
Using a screwdriver, detach the 4 clips.
- HINT:
- Tape the screwdriver tip before use.
Disconnect the connector and remove the upper rear console panel.
| 7.
REMOVE CENTER POWER OUTLET SOCKET ASSEMBLY |
 |
Rotate the socket to disengage the notch.
- Pull out the socket halfway and rotate the socket until its protrusion is aligned with the groove of the cover.
Remove the socket from the cover.