REMOVAL
Removal / installation · Vehicles built Nov 2005 – Dec 2006
Versions by build date: Nov 2005 – Dec 2006 from Jan 2007
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
| 2.
REMOVE REAR DOOR SCUFF PLATE LH
|
 |
- Using a screwdriver, detach the 8 claws and remove the scuff plate.
- HINT:
- Tape the screwdriver tip before use.
| 3.
REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH
|
 |
- Using a screwdriver, detach the 8 claws and remove the scuff plate.
- HINT:
- Tape the screwdriver tip before use.
| 4.
REMOVE PACKAGE TRAY TRIM POCKET SUB-ASSEMBLY |
|
| 5.
REMOVE TONNEAU COVER ASSEMBLY |
|
| 6.
REMOVE REAR FLOOR NO. 1 BOARD |
|
| 7.
REMOVE DECK BOARD ASSEMBLY |
|
| 8.
REMOVE REAR FLOOR NO. 3 BOARD |
|
| 9.
REMOVE REAR FLOOR NO. 2 BOARD |
|
| 10.
REMOVE JACK CARRIER ASSEMBLY
|
 |
Using a clip remover, remove the 7 clips and remove the jack carrier.
| 11.
REMOVE REAR FLOOR NO. 1 MAT SUPPORT SIDE PLATE
|
 |
Remove the 4 screws.
Using a clip remover, detach the 7 clips and remove the plate.
| 12.
REMOVE BACK DOOR WEATHERSTRIP |
|
| 13.
REMOVE REAR FLOOR FINISH PLATE
|
 |
- Using a clip remover, detach the 6 clips and remove the finish plate.
| 14.
REMOVE RECLINING REMOTE CONTROL LEVER BEZEL LH |
|
| 15.
REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR COVER
|
 |
Using a screwdriver, detach the 4 claws and remove the cover.
- HINT:
- Tape the screwdriver tip before use.
| 16.
REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR BRACKET
|
 |
- Remove the bolt, 2 washers, collar and bracket.
| 17.
REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
|
 |
- Disconnect the rear No. 1 seat belt's floor anchor.
Remove the anchor cover.
Remove the bolt and disconnect the floor anchor.
- Remove the bolt and 2 screws.
Using a screwdriver, detach the 5 claws.
- HINT:
- Tape the screwdriver tip before use.
Using a clip remover, detach the 5 clips and remove the trim board.
Disconnect the power outlet socket connector.
Remove the belt hanger.
| 18.
REMOVE REAR POWER OUTLET SOCKET ASSEMBLY |
 |
Detach the 2 claws fittings and remove the socket.