2005-2008 RAV4 · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Jan 2007

Versions by build date: Nov 2005 – Dec 2006 from Jan 2007


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


2. REMOVE REAR DOOR SCUFF PLATE LH

  1. B129711
    Using a screwdriver, detach the 8 claws and remove the scuff plate.

    HINT:
    Tape the screwdriver tip before use.


3. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

4. REMOVE PACKAGE TRAY TRIM POCKET SUB-ASSEMBLY

5. REMOVE TONNEAU COVER ASSEMBLY

6. REMOVE REAR FLOOR NO. 1 BOARD

7. REMOVE DECK BOARD ASSEMBLY

8. REMOVE REAR FLOOR NO. 3 BOARD

9. REMOVE REAR FLOOR NO. 2 BOARD

10. REMOVE JACK CARRIER ASSEMBLY

B129715
  1. Using a clip remover, remove the 7 clips and remove the jack carrier.


11. REMOVE REAR FLOOR NO. 1 MAT SUPPORT SIDE PLATE

B129717
  1. Remove the 4 screws.

  1. Using a clip remover, detach the 7 clips and remove the plate.


12. REMOVE BACK DOOR WEATHERSTRIP

13. REMOVE REAR FLOOR FINISH PLATE

  1. B129716
    Using a clip remover, detach the 6 clips and remove the finish plate.


14. REMOVE RECLINING REMOTE CONTROL LEVER BEZEL LH

15. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR COVER

B131613
  1. Using a screwdriver, detach the 4 claws and remove the cover.

    HINT:
    Tape the screwdriver tip before use.


16. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR BRACKET

  1. B130163
    Remove the bolt, 2 washers, collar and bracket.


17. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

  1. B137546
    Disconnect the rear No. 1 seat belt's floor anchor.

    1. Remove the anchor cover.

    2. Remove the bolt and disconnect the floor anchor.

  1. B129712
    Remove the bolt and 2 screws.

  1. Using a screwdriver, detach the 5 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a clip remover, detach the 5 clips and remove the trim board.

  1. Disconnect the power outlet socket connector.

  1. Remove the belt hanger.


18. REMOVE REAR POWER OUTLET SOCKET ASSEMBLY

B133576
  1. Detach the 2 claws fittings and remove the socket.

← REMOVAL (Nov 2005 – Dec 2006)INSTALLATION (Nov 2005 – Dec 2006) →