ON-VEHICLE INSPECTION
Inspection · Vehicles built from Nov 2005
| CHECK WINDSHIELD DEICER SWITCH |
Disconnect the windshield deicer switch connector.
Measure the voltage and resistance of the switch.

- Standard voltage:
Tester Connection
Condition
Specified Condition
1 (ILL+) - 6 (ILL-)
Headlight dimmer switch OFF → ON
Below 1 V → 10 to 14 V
8 (D) - 5 (E)
Ignition switch on (IG)
10 to 14 V
4 (IG) - 5 (E)
Ignition switch on (IG)
10 to 14 V
- Standard resistance:
Tester Connection
Condition
Specified Condition
6 (ILL-) - Body ground
Always
Below 1 Ω
5 (E) - Body ground
Always
Below 1 Ω
Reconnect the windshield deicer connector.
Measure the voltage of the switch.

- Standard voltage:
Tester Connection
Condition
Specified Condition
8 (D) - 5 (E)
Ignition switch on (IG), windshield deicer switch OFF → ON
10 to 14 V → Below 1 V (after 15 +-3 minutes: 10 to 14 V)
4 (IG) - 5 (E)
Ignition switch on (IG), windshield deicer switch ON
10 to 14 V → Below 1 V
Check the ON/OFF indicator of the switch.

Push the switch several times. Check that the ON/OFF indicator illuminates or turns off according to the switch operation.
Check the illumination area of the switch.

Check that the ON/OFF indicator illuminates or turns off according to the switch operation.
