2005-2008 RAV4 · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Nov 2005


INSPECT AXIAL PLAY OF TURBINE SHAFT

  1. A130400
    Insert the needle of a dial indicator into the exhaust side of the turbine shaft.

  1. Move the turbine shaft in an axial direction and measure the axial play of the turbine shaft using the dial indicator.

    Maximum axial play:
    0.08 mm (0.0031 in.)

    If the axial play is greater than the maximum, replace the turbocharger.


INSPECT RADIAL PLAY OF TURBINE SHAFT

  1. A130402
    Insert the needle of a dial indicator into the oil outlet hole, and set it in the center of the turbine shaft.

  1. Move the turbine shaft in a radial direction and measure the radial play of the turbine shaft using the dial indicator.

    Maximum radial play:
    0.110 mm (0.0043 in.)

    If the radial play is greater than the maximum, replace the turbocharger.


INSPECT ACTUATOR AND WASTE GATE VALVE OPERATION
  1. Disconnect the actuator hose from the compressor housing.

  1. A130404
    Using SST, apply pressure to the actuator.
    SST
    09992-00242  

    Standard pressure:
    114 kPa (1.16 kgf/cm2, 16.5 psi)

    NOTICE:
    Never apply more than 147 kPa (1.5 kgf/cm2, 21.3 psi) of pressure to the actuator.

  1. Check that the actuator push rod moves and that the waste gate valve opens. If the rod does not move, replace the actuator or turbocharger.

  1. Connect the actuator hose to the compressor housing.

← REMOVAL (from Aug 2007)INSTALLATION (Nov 2005 – Dec 2006) →