2005-2008 RAV4 · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built from Jan 2007

Versions by build date: Nov 2005 – Dec 2006 from Jan 2007


1. REMOVE PACKAGE TRAY TRIM POCKET SUB-ASSEMBLY

2. REMOVE TONNEAU COVER ASSEMBLY

3. REMOVE REAR FLOOR NO. 1 BOARD

4. REMOVE DECK BOARD ASSEMBLY

5. REMOVE REAR FLOOR NO. 3 BOARD

6. REMOVE REAR FLOOR NO. 2 BOARD

7. REMOVE JACK CARRIER ASSEMBLY (for Short Body)

B129715
  1. Using a clip remover, remove the 7 clips and remove the jack carrier.


8. REMOVE REAR FLOOR NO. 1 MAT SUPPORT SIDE PLATE (for Short Body)

B129717
  1. Remove the 4 screws.

  1. Using a clip remover, detach the 7 clips and remove the plate.


9. REMOVE REAR FLOOR NO. 1 MAT SUPPORT SIDE PLATE (for Long Body)

B129705
  1. Remove the 4 screws.

  1. Using a clip remover, detach the 7 clips and remove the plate.


10. REMOVE BACK DOOR WEATHERSTRIP

11. REMOVE REAR FLOOR FINISH PLATE (for Short Body)

  1. B129716
    Using a clip remover, detach the 6 clips and remove the finish plate.


12. REMOVE REAR FLOOR FINISH PLATE (for Long Body)

B129704
  1. Using a clip remover, detach the 6 clips.

  1. Detach the 2 claws and remove the finish plate.


13. REMOVE RECLINING REMOTE CONTROL LEVER BEZEL RH

  1. B135482
    Using a screwdriver, detach the 6 claws and remove the bezel.

    HINT:
    Tape the screwdriver tip before use.


14. REMOVE TETHER ANCHOR BRACKET SUB-ASSEMBLY (for Long Body)

  1. B135674
    Remove the bolt and tether anchor bracket.


15. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR COVER (for Short Body)

B131613
  1. Using a screwdriver, detach the 4 claws and remove the cover.

    HINT:
    Tape the screwdriver tip before use.


16. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR BRACKET (for Short Body)

  1. B130163
    Remove the bolt, 2 washers, collar and bracket.


17. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH (for Short Body)

  1. B137547
    Disconnect the rear No. 1 seat belt's floor anchor.

    1. Remove the anchor cover.

    2. Remove the bolt and disconnect the floor anchor.

  1. B129713
    Remove the bolt and 2 screws.

  1. Using a screwdriver, detach the 5 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a clip remover, detach the 5 clips and remove the trim board.

  1. Remove the belt hanger.


18. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH (for Long Body)

  1. B137547
    Disconnect the rear No.1 seat outer belt's floor anchor.

    1. Remove the anchor cover.

    2. Remove the bolt and disconnect the floor anchor.

  1. B129707
    Remove the 2 screws and 2 bolts.

  1. Using a screwdriver, detach the 5 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a clip remover, detach the 4 clips and remove the trim board.

  1. Remove the belt hanger.


19. REMOVE RECLINING REMOTE CONTROL LEVER SUB-ASSEMBLY RH

  1. B135481
    Remove the 2 bolts and lever.

  1. Disconnect the rear No. 1 seat lock cable from the lever.


20. REMOVE REAR NO. 3 SEAT LEG SIDE COVER

  1. B131530
    Using a screwdriver, detach the 4 claws and remove the side cover.

    HINT:
    Tape the screwdriver tip before use.


21. REMOVE REAR NO. 2 SEAT LEG SIDE COVER

  1. B131533
    Using a screwdriver, detach the 3 claws and clip, remove the side cover.

    HINT:
    Tape the screwdriver tip before use.


22. REMOVE REAR SEAT LEG COVER

  1. B131527E01
    Using a screwdriver, detach the 8 claws and remove the 2 leg covers.

    HINT:
    Tape the screwdriver tip before use.


23. REMOVE REAR NO. 1 SEAT LOCK CABLE ASSEMBLY

  1. Disconnect the lock cable from the seat.

    1. Raise the adjuster's lock piece to release the lock.

      B140555E01

    2. B140556E01
      Slide the seat forward and tilt the seatback forward.

    3. B140558E01
      Remove the seat's cap from the connector case.

    4. B140559E01
      Pull the seat's cap toward the outside of the vehicle. Then remove the cable from the connector case's slit.

    5. B140561E01
      Remove the body's cap from the connector case.

  1. Detach the clamps and remove the lock cable.

    B132540E01


24. REMOVE REAR NO. 1 SEAT ASSEMBLY RH
  1. Lift up the seat track adjusting handle and move the seat to the rearmost position.

  1. B131536
    Remove the 2 bolts on the front side of the seat.

  1. Lift up the seat track adjusting handle and move the seat to the foremost position.

  1. B131535
    Remove the 3 bolts on the rear side of the seat.

  1. Fully tilt the seatback forward. Then remove the seat.

    NOTICE:
    Be careful not to damage the vehicle body,

← REMOVAL (Nov 2005 – Dec 2006)DISASSEMBLY (Nov 2005 – Dec 2006) →