2005-2008 RAV4 · Service Manual SUSPENSION & AXLE

REPLACEMENT

Removal / installation · Vehicles built Nov 2005 – Dec 2006

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are the LH side.


1. REMOVE FRONT WHEEL

2. REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY LH

C127058
  1. Remove the 2 bolts and cylinder.


3. REMOVE FRONT DISC

  1. C127063E01
    Put matchmarks on the disc and axle hub.

  1. Remove the disc.


4. REMOVE FRONT AXLE HUB BOLT

C130491E01
  1. Using SST, remove the hub bolt that needs to be replaced.

    SST
    09650-17011  


5. INSTALL FRONT AXLE HUB BOLT

  1. C127538E01
    Insert a new hub bolt into the bolt hole. Set a plate washer and nut on the hub bolt end.

  1. Using a brass bar or equivalent to hold the front axle, install the hub bolt by tightening the nut. Then remove the nut and plate washer.


6. INSTALL FRONT DISC

  1. C127063E01
    Align the matchmarks and install the disc.

    HINT:
    When replacing the disc with a new one, select the installation position where the disc has the minimum runout.


7. INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY LH

  1. C127069E01
    Apply silicon grease (Multemp SI-B) on the contact surfaces of the cylinder parts indicated by the arrows.

  1. C127058
    Install the cylinder with the 2 bolts.

    Torque:
    34.3 N*m{ 350 kgf*cm , 25 ft.*lbf }


8. INSTALL FRONT WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }

← COMPONENTS (from Nov 2005)REPLACEMENT (Jan 2007 – Jul 2007) →