REPLACEMENT
Removal / installation · Vehicles built Jan 2007 – Jul 2007
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007
- HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are the LH side.
| 2.
REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY LH
|
 |
Remove the 2 bolts and cylinder.
| 3.
REMOVE FRONT DISC
|
 |
- Put matchmarks on the disc and axle hub.
Remove the disc.
| 4.
REMOVE FRONT AXLE HUB BOLT |
 |
Using SST, remove the hub bolt that needs to be replaced.
- SST
- 09650-17011
| 5.
INSTALL FRONT AXLE HUB BOLT |
 |
- Insert a new hub bolt into the bolt hole. Set a plate washer and nut on the hub bolt end.
Using a brass bar or equivalent to hold the front axle, install the hub bolt by tightening the nut. Then remove the nut and plate washer.
| 6.
INSTALL FRONT DISC
|
 |
- Align the matchmarks and install the disc.
- HINT:
- When replacing the disc with a new one, select the installation position where the disc has the minimum runout.
| 7.
INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY LH
|
 |
- Apply silicon grease (Multemp SI-B) on the contact surfaces of the cylinder parts indicated by the arrows.
- Install the cylinder with the 2 bolts.
-
Torque:
- 34.3 N*m{
350 kgf*cm
, 25 ft.*lbf
}
| 8.
INSTALL FRONT WHEEL |
 |
-
Torque:
- 103 N*m{
1,050 kgf*cm
, 76 ft.*lbf
}