2005-2008 RAV4 · Service Manual SUSPENSION & AXLE

REPLACEMENT

Removal / installation · Vehicles built Nov 2005 – Dec 2006

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are the LH side.


1. REMOVE REAR WHEEL

2. REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY LH

C127286
  1. Remove the 2 bolts and cylinder.


3. REMOVE REAR DISC

  1. C129072E01
    Put matchmarks on the disc and axle hub.

  1. Release the parking brake.

  1. C127304
    Turn the shoe adjuster until the disc turns freely, and then remove the disc.

  1. Install the shoe adjusting hole plug to the rear disc.


4. REMOVE REAR AXLE HUB BOLT

C130576E01
  1. Using SST and a brass bar or equivalent to hold the axle shaft, remove the hub bolt that needs to be replaced.

    SST
    09650-17011  


5. INSTALL REAR AXLE HUB BOLT

  1. C127567E01
    Insert a new hub bolt into the bolt hole. Set a plate washer and nut on the hub bolt end.

  1. Using a brass bar or equivalent to hold the rear axle, install the hub bolt by tightening the nut. Then remove the nut and plate washer.


6. INSTALL REAR DISC

  1. C127291E01
    Align the matchmarks and install the disc.

    HINT:
    When replacing the disc with a new one, select the installation position where the disc has the minimum runout.


7. INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY LH

  1. C127297E01
    Apply silicon grease (Multemp SI-B) on the contact surfaces of the cylinder parts indicated by the arrows.

  1. C127286
    Install the cylinder with the 2 bolts.

    Torque:
    26.5 N*m{ 270 kgf*cm , 20 ft.*lbf }


8. INSTALL REAR WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }

← COMPONENTS (from Nov 2005)REPLACEMENT (Jan 2007 – Jul 2007) →