REPLACEMENT
Removal / installation · Vehicles built from Aug 2007
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007
- HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are the LH side.
| 2.
REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY LH
|
 |
Remove the 2 bolts and cylinder.
| 3.
REMOVE REAR DISC
|
 |
- Put matchmarks on the disc and axle hub.
Release the parking brake.
- Turn the shoe adjuster until the disc turns freely, and then remove the disc.
Install the shoe adjusting hole plug to the rear disc.
| 4.
REMOVE REAR AXLE HUB BOLT |
 |
Using SST and a brass bar or equivalent to hold the axle shaft, remove the hub bolt that needs to be replaced.
- SST
- 09650-17011
| 5.
INSTALL REAR AXLE HUB BOLT |
 |
- Insert a new hub bolt into the bolt hole. Set a plate washer and nut on the hub bolt end.
Using a brass bar or equivalent to hold the rear axle, install the hub bolt by tightening the nut. Then remove the nut and plate washer.
| 6.
INSTALL REAR DISC
|
 |
- Align the matchmarks and install the disc.
- HINT:
- When replacing the disc with a new one, select the installation position where the disc has the smallest runout.
| 7.
INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY LH
|
 |
- Install the cylinder with the 2 bolts.
-
Torque:
- 26.5 N*m{
270 kgf*cm
, 20 ft.*lbf
}
| 8.
INSTALL REAR WHEEL |
 |
-
Torque:
- 103 N*m{
1,050 kgf*cm
, 76 ft.*lbf
}