2005-2008 RAV4 · Service Manual TRANSMISSION

INSPECTION

Inspection · Vehicles built from Nov 2005


INSPECT REVERSE IDLER GEAR SUB-ASSEMBLY

C069503E01
  1. Using a caliper gauge, measure the inside diameter of the reverse idler gear.

    Standard inside diameter:
    20.056 to 20.074 mm (0.7896 to 0.7903 in.)

    Maximum inside diameter:
    20.074 (0.7903 in.)

    If the inside diameter is greater than the maximum, replace the reverse idler gear.

  1. C069505E02
    Using a micrometer, measure the diameter of the reverse idler gear shaft.

    Standard diameter:
    19.984 to 20.000 mm (0.7868 to 0.7874 in.)

    Minimum diameter:
    19.984 mm (0.7868 in.)

    If the diameter is less than the minimum, replace the reverse idler gear shaft.


INSPECT NO. 3 TRANSAXLE CLUTCH HUB

C069509E01
  1. Inspect the sliding condition between the No. 3 transaxle clutch hub and the No. 3 transaxle hub sleeve.

  1. Inspect the tip of the spline gear on the No. 3 transaxle hub sleeve for wear.


INSPECT NO. 3 TRANSAXLE HUB SLEEVE

C070509E04
  1. Using vernier calipers, measure the width of the No. 3 transaxle hub sleeve groove (A) and the thickness of the claw part on the No. 3 gear shift fork (B), and calculate the clearance.

    Standard clearance:
    A - B = 0.15 to 0.35 mm (0.0059 to 0.0138 in.)
    If the clearance is out of the specification, replace the No. 3 transaxle hub sleeve and No. 3 gear shift fork with new ones.


INSPECT 5TH GEAR

C069768E01
  1. Using a caliper gauge, measure the inside diameter of the 5th gear.

    Standard inside diameter:
    34.981 to 34.997 mm (1.3772 to 1.3778 in.)

    Maximum inside diameter:
    34.997 mm (1.3778 in.)

    If the inside diameter is greater the maximum, replace the 5th gear.

← DISASSEMBLY (from Nov 2005)REASSEMBLY (from Nov 2005) →