DISASSEMBLY
Removal / installation · Vehicles built from Aug 2007
| 1.
REMOVE GENERATOR PULLEY WITH CLUTCH |
 |
- Using a screwdriver, puncture the center of the cap and pry it off the pulley.
- NOTICE:
- Do not reuse the cap.
- Install SST to the pulley as shown in the illustration.
- SST
- 09820-63020
Mount SST (A) in a vise.
- Turn SST (B) clockwise to loosen the pulley.
Remove the pulley.
| 2.
REMOVE GENERATOR BRUSH HOLDER ASSEMBLY |
 |
- Remove the bolt and wire harness clamp stay.
- Remove the bolt and bracket.
- Remove the 3 nuts and generator rear end cover.
- Remove the terminal insulator.
- Remove the 2 screws and generator brush holder.
| 3.
REMOVE GENERATOR ROTOR ASSEMBLY |
 |
- Remove the 4 bolts.
- Using SST, remove the generator rectifier end frame.
- SST
- 09950-40011
(09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)
Remove the washer.
Remove the generator rotor.