2005-2008 RAV4 · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Aug 2007


INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

  1. A079305E04
    Using a vernier caliper, measure the brush length.

    Standard length:
    9.5 to 11.5 mm (0.374 to 0.453 in.)

    Minimum length:
    4.5 mm (0.177 in.)

    If the brush length is less than the minimum, replace the generator brush holder assembly.


INSPECT GENERATOR ROTOR ASSEMBLY

  1. A097476E02
    Check the resistance.

    1. Measure the resistance between the slip rings.

      Standard resistance:
      1.5 to 1.9 Ω at 20°C (68°F)

      If the result is not as specified, replace the generator rotor assembly.

    2. A097477E02
      Measure the resistance between one of the slip rings and the rotor core.

      Standard resistance:
      1 MΩ or higher

      If the result is not as specified, replace the generator rotor assembly.

  1. A097470E02
    Check the slip ring diameter.

    1. Using a vernier caliper, measure the slip ring diameter.

      Standard diameter:
      14.2 to 14.4 mm (0.559 to 0.567 in.)

      Minimum diameter:
      14 mm (0.551 in.)

      If the diameter is less than the minimum, replace the generator rotor assembly.

  1. Check the appearance.

    1. A097469E01
      Check that the bearing is not rough or worn.

      OK:
      The bearing rotates smoothly.

      If the result is not as specified, replace the generator rotor assembly.


INSPECT GENERATOR DRIVE END FRAME BEARING

  1. A136846
    Check that the bearing is not rough or worn.

    OK:
    The bearing rotates smoothly.

    If the bearing does not rotate smoothly, replace the bearing.


INSPECT GENERATOR PULLEY WITH CLUTCH

  1. A118368E01
    Hold the center of the pulley, and confirm that the outer ring turns counterclockwise and does not turn clockwise.
    If the result is not as specified, replace the generator pulley with clutch.

← DISASSEMBLY (from Aug 2007)REPLACEMENT (from Aug 2007) →