2005-2008 RAV4 · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Aug 2007


1. INSTALL GENERATOR ROTOR ASSEMBLY

  1. A097468E01
    Install the washer onto the generator rectifier end frame.

  1. A097467E01
    Install the generator rotor onto the generator rectifier end frame.

  1. A136848E01
    Using a 21 mm deep socket wrench and press, slowly push the generator drive end frame onto the generator rectifier frame.

  1. A136842
    Install the 4 bolts.

    Torque:
    5.8 N*m{ 59 kgf*cm , 51 in.*lbf }


2. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY

  1. A079315E04
    While pushing the 2 brushes into the generator brush holder, insert a φ1.0 mm (0.039 in.) pin into the generator brush holder.

  1. A079316E02
    Install the generator brush holder with the 2 screws.

    Torque:
    1.8 N*m{ 18 kgf*cm , 16 in.*lbf }

  1. Pull the pin out of the generator brush holder.

  1. A136840
    Install the terminal insulator onto the generator rectifier end frame.

  1. A136839
    Install the generator rear end cover with the 3 nuts.

    Torque:
    4.6 N*m{ 47 kgf*cm , 41 in.*lbf }

  1. A132435
    Install the bracket with the bolt.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

  1. A132434
    Install the wire harness clamp stay.

    Torque:
    8.4 N*m{ 86 kgf*cm , 74 in.*lbf }


3. INSTALL GENERATOR PULLEY WITH CLUTCH
  1. Install the pulley by hand.

  1. A136849E01
    Install SST to the pulley as shown in the illustration.
    SST
    09820-63020  

  1. A136850E01
    Turn SST (B) counterclockwise to tighten the pulley.

    Torque:
    110 N*m{ 1122 kgf*cm , 82 ft.*lbf }

  1. Install a new cap to the pulley.

  1. Check that the generator pulley rotates smoothly.

← REPLACEMENT (from Aug 2007)INSTALLATION (from Aug 2007) →