2005-2008 RAV4 · Service Manual CRUISE CONTROL SYSTEM

P1631/65 Communication Error from ECM to Skid Control ECU

Diagnostic trouble codes · Vehicles built from Nov 2005

Also covers:

DESCRIPTION

Therefore, if the skid control ECU detects a communication error from the ECM, it sends a malfunction signal back to the ECM.
DTC No.
DTC Detection Condition
Trouble Area
P1631/65
While the cruise control is either preparing for operation or operating, if the ECM continuously receives a logical error signal from the skid control ECU for a certain amount of time, the ECM records this logical error code
  1. Communication circuit
  2. ECM
  3. Skid control ECU
U0100/78
While the cruise control is either preparing for operation or operating, if the ECM continuously receives a communication cut off signal from the skid control ECU for a certain amount of time, the ECM records this communication cut off code
  1. Communication circuit
  2. ECM
  3. Skid control ECU

INSPECTION PROCEDURE

HINT:
This circuit uses CAN communication. Therefore, if there are any malfunctions in the communication circuit, one or more DTCs in the CAN communication system are output.


1.CHECK CAN COMMUNICATION SYSTEM
    Refer to HOW TO PROCEED WITH TROUBLESHOOTING (Click here).

← P1630/64 Communication Error from Skid Control ECU to ECM (+ U0122/82) (from Nov 2005)Clutch Switch Circuit (from Nov 2005) →