2005-2008 RAV4 · Service Manual CRUISE CONTROL SYSTEM

Clutch Switch Circuit

Circuit diagnosis · Vehicles built from Nov 2005

DESCRIPTION

This circuit sends signals to the ECM depending on the clutch switch condition.

WIRING DIAGRAM

E125036E02

INSPECTION PROCEDURE


1. INSPECT CLUTCH SWITCH ASSEMBLY
E118525
  1. Remove the clutch switch.

  1. Measure the resistance of the switch.

    Standard resistance:
    Tester Connection
    Specified Condition
    1 - 2
    Below 1 Ω



NG
REPLACE CLUTCH SWITCH ASSEMBLY
OK


2. CHECK ECM
E125315E01
  1. Disconnect the B32*1 or A12*2 ECM connection.

    HINT:
    *1: for 1AZ-FE, 2AZ-FE
    *2: for 2AD-FHV, 2AD-FTV

  1. Turn the ignition switch on (IG).

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    for 1AZ-FE, 2AZ-FE 
    Tester Connection
    Switch Condition
    Specified Condition
    B32-56 (D) - Body ground
    Clutch switch ON
    10 to 14 V

    for 2AD-FHV, 2AD-FTV:
    Tester Connection
    Switch Condition
    Specified Condition
    A12-42 (CLSW) - Body ground
    Clutch switch ON
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← P1631/65 Communication Error from ECM to Skid Control ECU (+ U0100/78) (from Nov 2005)Cruise Control Switch Circuit (Nov 2005 – Jul 2007) →