2005-2008 RAV4 · Service Manual BRAKE

C1241/41 Low Battery Positive Voltage

Diagnostic trouble codes · Vehicles built Jan 2007 – Jul 2007

Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007

DESCRIPTION

When there is an abnormality in the power supply circuit of the brake actuator (skid control ECU), the skid control ECU sets a DTC and the operation is prohibited by the fail-safe function. This DTC is set when the voltage supplied to terminal IG1 is outside the DTC detection threshold, due to abnormalities of the battery, power source circuits or charging circuits, such as the alternator circuit.
The fail-safe function is canceled when the voltage to terminal IG1 returns to normal.
DTC No.
DTC Detection Condition
Trouble Area
C1241/41
When one of following conditions is met:
  1. At vehicle speed of 3 km/h (2 mph) or more, IG1 terminal voltage is 9.5 V or less for 10 seconds or more.
  2. When solenoid relay remains ON and IG1 terminal voltage is 9.5 V or less, relay contact open for 0.2 seconds or more.
  3. When motor relay remains ON and IG1 terminal voltage becomes 9.5 V or less, actuator pump motor is OFF for 0.1 seconds or more.
  4. When IG1 terminal voltage is 9.5 V or less, vehicle speed sensor power supply decreases for 60 seconds or more.
  1. Battery
  2. Charging system
  3. Power source circuit
  4. Internal power supply circuit of skid control ECU

WIRING DIAGRAM

C126322E01
C126323E01

INSPECTION PROCEDURE


1. INSPECT FUSE (ECU-IG1)
  1. Remove the ECU-IG1 fuse from the instrument panel junction block.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2. INSPECT BATTERY
  1. Check the battery voltage.

    Standard voltage:
    11 to 14 V



NG
CHECK CHARGING SYSTEM
OK


3. CHECK WIRE HARNESS (SKID CONTROL ECU - BATTERY)

  1. C117862E08
    Disconnect the A27 ECU connector.

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    A27-25 (IG1) - Body ground
    Ignition switch on (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


4. CHECK WIRE HARNESS (SKID CONTROL ECU - BODY GROUND)

  1. C117862E09
    Disconnect the A27 ECU connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    A27-2 (GND1) - Body ground
    Below 1 Ω
    A27-24 (GND2) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


5. RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Drive the vehicle at 3 km/h (2 mph) or more for several seconds.

  1. Check if the same DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
END
A

REPLACE BRAKE ACTUATOR ASSEMBLY


← C1241/41 Low Battery Positive Voltage (Nov 2005 – Dec 2006)C1241/41 Low Battery Positive Voltage (from Aug 2007) →