2005-2008 RAV4 · Service Manual HEATER & AIR CONDITIONING SYSTEM

Compressor Circuit

Circuit diagnosis · Vehicles built from Aug 2007

DESCRIPTION

When the A/C switch is turned on, the magnetic clutch ON signal is sent from the air conditioning amplifier. Then the MG CLT relay turns on to operate the magnetic clutch.

WIRING DIAGRAM

E143425E03

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (A/C MAG CLUTCH)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the intelligent tester main switch ON.

  1. Select the item below in the ACTIVE TEST and then check that the compressor magnetic relay operates.

    Air conditioning amplifier 
    Item
    Test Details / Display (Range)
    Diagnostic Note
    Magnetic Clutch Relay
    Magnetic clutch relay / OFF, ON
    Operating sound can be heard



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

2. INSPECT FUSE (ECU-IG1)
  1. Remove the ECU-IG1 fuse from the instrument panel junction block.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


3. INSPECT MAGNETIC CLUTCH RELAY (Marking: MG CLT)

  1. E127548E01
    Remove the magnetic clutch relay from the engine room No. 1 relay block.

  1. Measure the resistance of the relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)



NG
REPLACE MAGNETIC CLUTCH RELAY
OK


4. CHECK WIRE HARNESS (AIR CONDITIONING AMPLIFIER - BATTERY)

  1. E118637E14
    Disconnect the E41 amplifier connector.

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E41-20 (MGC) - Body ground
    Ignition switch on (IG)
    10 to 14 V
    E41-20 (MGC) - Body ground
    Ignition switch Off
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5. CHECK AIR CONDITIONING AMPLIFIER (MGC VOLTAGE)

  1. E115805E08
    Remove the air conditioning amplifier with its connectors still connected.

  1. Measure the voltage of the connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E41-20 (MGC) - Body ground
    Ignition switch ON
    A/C switch OFF
    10 to 14 V
    E41-20 (MGC) - Body ground
    Ignition switch ON
    A/C switch ON
    Below 1.5 V



NG
REPLACE AIR CONDITIONING AMPLIFIER
OK


6. CHECK MAGNETIC CLUTCH

  1. E127549E01
    Disconnect the B82 magnetic clutch connector.

  1. Connect the battery's positive (+) lead to terminal 3 of the magnetic clutch and the negative (-) lead to the body ground.

    OK:
    Magnetic clutch is engaged.



NG
REPLACE MAGNETIC CLUTCH
OK

REPAIR OR REPLACE WIRE HARNESS (MAGNETIC CLUTCH - ECU-IG1)


← Blower Motor Circuit (from Nov 2005)PTC Heater Circuit (from Nov 2005) →