INSPECTION
Inspection · Vehicles built from Aug 2007
| INSPECT COMPRESSOR AND MAGNETIC CLUTCH |
Disconnect the connector from the compressor and magnetic clutch.

Disconnect the connector from the magnetic clutch.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
3 (MG+) - 1
Always
Below 1 Ω
3 (MG+) - Body ground
Always
10 kΩ or higher
| INSPECT MAGNET CLUTCH ASSEMBLY |
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Tester Connection
Condition
Specified Condition
1 - Body ground
Always
3.4 to 3.8 Ω
When connector terminal A1 is connected to the positive (+) battery terminal, check that the following occurs: 1) the magnetic clutch's operating sound can be heard, and 2) the magnetic clutch's hub and rotor lock.
If the result is not as specified, replace the magnetic clutch.
| INSPECT COMPRESSOR AND MAGNETIC CLUTCH (LOCK SENSOR) |
Measure the resistance of the sensor.

- Standard resistance:
Tester Connection
Condition
Specified Condition
1(SSR+) - 2(SSR-)
20°C (68°F)
65 to 125 Ω
