REASSEMBLY
Removal / installation · Vehicles built Aug 2007 – Jul 2008
| 1.
INSTALL FUEL PUMP |
 |
- Connect the pump harness connector.
- Apply gasoline to a new O-ring and install the O-ring to the fuel filter.
Engage the 5 claws to the claw holes and install the fuel pump.
- NOTICE:
- Do not damage the fuel pump filter.
| 2.
INSTALL NO. 1 FUEL SUCTION SUPPORT |
 |
- Engage the 2 claws to the claw holes and install the No. 1 fuel suction support.
| 3.
INSTALL NO. 1 FUEL SUB-TANK |
 |
- Apply gasoline to a new O-ring and install it to the jet pump.
- Install the jet pump while aligning it to the installation position of the sub-tank.
Install the jet pump nozzle.
- Engage the 2 claws to the claw holes and install the fuel filter to the sub-tank.
- Connect the wire harness.
- Install the 2 springs to the fuel suction plate shafts and install them to the sub-tank.
- Using needle-nose pliers, install a new E-ring.
- HINT:
- Slightly lower the sub-tank to install the E-ring.