INSPECTION
Inspection · Vehicles built from Aug 2008
| INSPECT STOP LIGHT CONTROL RELAY ASSEMBLY |
Disconnect the A43 stop light control relay connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
A43-2 (STP) - Body ground
Brake pedal released
Below 1 V
Brake pedal depressed
11 to 14 V
A43-6 (+B) - Body ground
Always
11 to 14 V
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
A43-4 (GND) - Body ground
Always
Below 1 Ω
Reconnect the A43 stop light control relay connector.
Measure the voltage according to the value(s) in the table below.

- Standard Voltage:
Tester Connection
Condition
Specified Condition
A43-8 (OUT) - Body ground
Brake pedal released
Below 1 V
Brake pedal depressed
11 to 14 V
