HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Aug 2008
Versions by build date: Nov 2005 – Jul 2008 from Aug 2008
- HINT:
- Use these procedures to troubleshoot the sliding roof system.
- *: Use the intelligent tester.
- Use these procedures to troubleshoot the sliding roof system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
| |||||
| 3.INSPECT COMMUNICATION FUNCTION OF MULTIPLEX COMMUNICATION SYSTEM (CAN)* |
Using the intelligent tester, check if the Multiplex Communication System (CAN) is functioning normally.
Result Result
Proceed to
CAN DTC is not output
A
CAN DTC is output
B
|
|||||
| |||||
| 4.PROBLEM SYMPTOMS TABLE |
| Result |
Proceed to |
| Fault is not listed in problem symptoms table |
A |
| Fault is listed in problem symptoms table |
B |
|
|||||
| |||||
| 5.VEHICLE BROUGHT TO WORKSHOP |
Data List / Active Test (Click here).
Terminals of ECU (Click here).
On-vehicle Inspection (Click here).
| |||||
| 6.ADJUST, REPAIR OR REPLACE |
| |||||
| 7.CONFIRMATION TEST |
| |||||