Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

Connecting terminals 13 (TC) and 4 (CG) of the DLC3 causes the skid control ECU to output 2-digit DTCs by flashing the ABS warning light/slip indicator light.

WIRING DIAGRAM


C203143E02


INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform zero point calibration (Click here).

1.CHECK DLC3 (TC VOLTAGE)


    C108847E50
  1. Turn the ignition switch to ON.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    E16-13 (TC) - Body ground
    Ignition switch ON
    11 to 14 V



NG
Go to step 3
OK


2.CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).

Result:
Result
Proceed to
DTC is not output.
A
DTC is output.
B



B
REPAIR CIRCUIT INDICATED BY OUTPUT DTC (Click here)
A

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)  

3.CHECK HARNESS AND CONNECTOR (DLC3 - ECM)


    C203144E02
  1. Turn the ignition switch off.

  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E16-13 (TC) - A12-26 (TC)
    Always
    Below 1 Ω
    A12-26 (TC) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)


    C108847E51
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E16-4 (CG) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).

    Result:
    Result
    Proceed to
    DTC is not output.
    A
    DTC is output.
    B



B
REPAIR CIRCUIT INDICATED BY OUTPUT DTC (Click here)
A

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)