Home › BRAKE › BRAKE CONTROL › ABS AND TRACTION ACTUATOR (w/ VSC)

ABS AND TRACTION ACTUATOR (w/ VSC) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



2. REMOVE AIR CLEANER BRACKET
  1. for 2AD-FTV:
    Install the air cleaner bracket (Click here).

  1. for 2AD-FHV:
    Install the air cleaner bracket (Click here).



3. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.



4. DISCONNECT CONNECTOR


    C191855
  1. Pull the lock lever upward and disconnect the connector.

    NOTICE:
    Be careful not to allow brake fluid to enter the removed connector.



5. DISCONNECT BRAKE LINE


    C191852E01
  1. Using a union nut wrench, disconnect the 6 brake lines from the actuator.



    C191854E01
  1. Place tags or marks to identify the installation locations of each brake line.



6. REMOVE BRAKE ACTUATOR WITH BRACKET


    C191856
  1. Disconnect the brake tube clamp from the bracket.



    C191857
  1. Remove the 3 nuts and actuator with bracket.

    NOTICE:
    Be careful not to damage the brake tubes.