ENGINE > ON-VEHICLE INSPECTION |
| 1. INSPECT ENGINE IDLE SPEED |
Warm up and stop the engine.
When using the intelligent tester:
Connect the intelligent tester to the DLC3.
Start the engine and idle it.
Enter the following menus: Powertrain / Engine / Data List / Engine SPD.
![]() |
When not using the intelligent tester:
Connect a tester probe of a tachometer to terminal 9 (TAC) of the DLC3 with SST.
Start the engine and idle it.
Inspect the engine idle speed.
Turn the ignition switch off.
Disconnect the intelligent tester or tachometer tester probe from the DLC3.
| 2. INSPECT MAXIMUM ENGINE SPEED |
Start the engine.
Fully depress the accelerator pedal.
Check the maximum engine speed.
| 3. INSPECT COMPRESSION |
Warm up and stop the engine.
Disconnect the connectors from the injectors.
Remove the glow plugs (Click here).
Inspect the cylinder compression pressure.
![]() |
Insert SST (attachment) into the glow plug hole.
| *1 | SST (Attachment) |
![]() |
Connect SST (compression gauge) to SST (attachment).
| *1 | SST (Compression Gauge) |
While cranking the engine, measure the compression pressure.
If the cylinder compression is low, pour a small amount of engine oil into the cylinder through the glow plug holes, then inspect it again.
If adding oil increases the compression pressure, the piston rings and/or cylinder bore may be worn or damaged.
If the pressure stays low, the valve may be stuck or seated improperly, or there may be leakage from the gasket.
Remove SST (attachment and compression gauge).
Connect the connectors to the injectors.
Install the glow plugs (Click here).