Home › TRANSMISSION · U660F AUTOMATIC TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM

DTC    P0560    System Voltage

for Preparation Click here


DESCRIPTION

The battery supplies electricity to the TCM even when the ignition switch is off. This power allows the TCM to store data such as DTC history and freeze frame data. If the battery voltage falls below a minimum level, this memory is cleared and the TCM determines that there is a malfunction in the power supply circuit. When the engine is next started, the TCM will illuminate the MIL and store the DTC.

DTC Code
DTC Detection Condition
Trouble Area
P0560
Open in TCM back-up power source circuit detected for 3 sec. or more (1-trip detection logic).
  1. Open in back-up power source circuit
  2. ECD system
  3. TCM

HINT:
If DTC P0560 is stored, the TCM does not store other DTCs.


WIRING DIAGRAM


C206305E02


INSPECTION PROCEDURE

1.CHECK DTC OUTPUT (ECD SYSTEM DTC P0560)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Powertrain / Engine / DTC.

  1. Read the DTCs using the intelligent tester.
    Result 
    Result
    Proceed to
    DTCs are not output
    A
    P0560 is output (ECD system)
    B



B
GO TO ECD SYSTEM (DTC P0560) (Click here)
A


2.CHECK TCM (POWER SOURCE, BODY GROUND)


    C205632E07
  1. Disconnect the TCM connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    B128-1 (BATT) - Body ground
    Always
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    B128-8 (E1) - Body ground
    Always
    Below 1 Ω

Text in Illustration 
*1
Front view of wire harness connector
(to TCM)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (TCM - BATTERY, BODY GROUND)
OK

REPLACE TCM (Click here)