STEERING COLUMN ASSEMBLY (for LHD) > INSTALLATION |
| 1. INSTALL STEERING COLUMN ASSEMBLY |
![]() |
Install the steering column to the instrument panel reinforcement with the 3 bolts.
| 2. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY |
Install the brake pedal support (Click here).
| 3. INSTALL NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY |
![]() |
Align the matchmarks on steering intermediate shaft and steering sliding yoke and temporarily install them with bolt B.
Align the matchmarks on the steering sliding yoke and steering gear assembly and install them with bolt A.
| 4. INSTALL COLUMN HOLE COVER SILENCER SHEET |
![]() |
Install the column hole cover silencer sheet with the 2 clips.
Install the floor carpet.
| 5. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag) |
![]() |
Attach the 8 claws to install the lower instrument panel finish panel.
Install the 2 screws.
| 6. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Knee Airbag) |
![]() |
Connect the connector.
Install the driver side knee airbag with the 4 bolts.
| 7. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Driver Side Knee Airbag) |
![]() |
Attach 3 claws to install the instrument panel under cover.
Install the 2 screws.
| 8. CONNECT POWER STEERING ECU |
![]() |
Connect the 2 steering column connectors to the power steering ECU.
Attach the clamps of the power steering motor wire harness and torque sensor wire harness.
Tilt the steering column up and down to make sure that the power steering motor wire harness and torque sensor wire harness do not interfere with any components.
| 9. INSTALL UPPER INSTRUMENT PANEL |
Install the upper instrument panel .
| 10. INSTALL COMBINATION SWITCH ASSEMBLY |
![]() |
Install the turn signal switch to the steering column with the clamp.
Connect all the connectors and attach all wire harness clamps to the steering column.
| 11. INSTALL SPIRAL CABLE SUB-ASSEMBLY |
Install the spiral cable onto the turn signal switch.
![]() |
Connect all the connectors to the turn signal switch with spiral cable.
| 12. INSTALL STEERING COLUMN COVER |
![]() |
Attach the claw to install the upper steering column cover.
![]() |
Attach the 4 claws to install the lower steering column cover.
| 13. INSTALL STEERING WHEEL ASSEMBLY |
![]() |
Align the matchmarks and install the steering wheel to the steering column.
Install the nut.
Connect all the connectors to the spiral cable.
| 14. INSTALL STEERING PAD (for Torx Type) |
![]() |
Support the steering pad with one hand as shown in the illustration.
Connect the 2 airbag connectors.
Connect the horn connector.
Install the steering pad after confirming that the circumference grooves of the screws are caught on the screw case.
![]() |
Using a T30 "torx" driver, install the 2 screws.
| 15. INSTALL STEERING PAD (for Pin Type) |
![]() |
Support the steering pad with one hand as shown in the illustration.
Connect the 2 airbag connectors.
Connect the horn connector.
Install the steering pad after confirming that the circumference grooves of the screws are caught on the screw case.
Attach the 2 spring to steering pad.
| 16. POSITION FRONT WHEELS FACING STRAIGHT AHEAD |
| 17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 18. INSPECT SRS WARNING LIGHT |
Inspect the SRS warning light (Click here).