Home › STEERING › POWER STEERING › POWER STEERING ECU (for RHD)

POWER STEERING ECU (for RHD) > INSTALLATION

for Preparation Click here



1. INSTALL POWER STEERING ECU


    C158026E01
  1. Check that the connector lever is the fully unlocked position before installation.

    NOTICE:
    If the lever has been lifted out of the fully unlocked position, it may cause an imperfect connection.



    C128907E04
  1. Install the ECU with the 3 nuts.

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 in.*lbf }

  1. Connect the 4 connectors.

  1. Lock the connector lever.

  1. Lightly pull on the connector and check that the connector will not be disconnected.



2. INSTALL UPPER INSTRUMENT PANEL
  1. Install the instrument panel (Click here).



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL