STEERING GEAR > INSTALLATION |
| 1. INSTALL TIE ROD END SUB-ASSEMBLY LH |
![]() |
Screw the lock nut and tie rod on the rack end until the matchmarks are aligned and temporarily tighten the lock nut.
| 2. INSTALL TIE ROD END SUB-ASSEMBLY RH |
| 3. INSTALL STEERING GEAR ASSEMBLY |
![]() |
Install the steering gear to the front suspension crossmember with the 2 bolts and 2 nuts.
| 4. INSTALL STEERING INTERMEDIATE SHAFT |
![]() |
Align the matchmarks and install the intermediate shaft to the steering gear.
| 5. INSTALL NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY |
Install the steering column hole cover to the steering gear with a new clamp.
| 6. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE |
for 2AD-FTV
Install the engine with transaxle (Click here).
for 2AD-FHV
Install the engine with transaxle (Click here).
| 7. INSTALL NO.2 STEERING INTERMEDIATE SHAFT ASSEMBLY |
![]() |
Attach clip B onto the body portion and install the No. 1 steering column hole cover to the body portion with clip A.
| 8. CONNECT STEERING SLIDING YOKE SUB-ASSEMBLY |
![]() |
Align the matchmarks and install the No. 2 steering intermediate shaft to the steering intermediate shaft.
| 9. INSTALL COLUMN HOLE COVER SILENCER SHEET |
![]() |
Install the column hole cover silencer sheet with the 2 clips.
Install the floor carpet.
| 10. CONNECT TIE ROD END SUB-ASSEMBLY LH |
![]() |
Connect the tie rod end onto the steering knuckle with the castle nut.
Install a new cotter pin.
| 11. CONNECT TIE ROD END SUB-ASSEMBLY RH |
| 12. INSTALL FRONT WHEELS |
| 13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 14. POSITION FRONT WHEELS FACING STRAIGHT AHEAD |
| 15. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |
Inspect and adjust the wheel alignment (Click here).