Home › STEERING › POWER STEERING › STEERING GEAR

STEERING GEAR > REMOVAL

for Preparation Click here



1. POSITION FRONT WHEELS FACING STRAIGHT AHEAD


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



3. REMOVE COLUMN HOLE COVER SILENCER SHEET


    C128486
  1. Turn back the floor carpet and remove the 2 clips and silencer sheet.



4. DISCONNECT NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY


    C128836
  1. Use a seat belt to fix the steering wheel in place to avoid breakage of the spiral cable.



    C128488E01
  1. Place matchmarks on the sliding yoke of the No. 2 steering intermediate shaft.

  1. Remove the bolt and disconnect the sliding yoke.



5. DISCONNECT NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY


    C128837E01
  1. Remove the clip A, detach the clip B from the body and disconnect the No. 1 steering column hole cover.

    NOTICE:
    Do not damage clips A and B.



6. REMOVE FRONT WHEELS


7. DISCONNECT TIE ROD END SUB-ASSEMBLY LH
  1. Remove the cotter pin and castle nut.



    C132680E01
  1. Using SST, disconnect the tie rod end from the steering knuckle.

    NOTICE:
    Do not damage the tie rod end dust cover.

    SST
    09628-62011  



8. DISCONNECT TIE ROD END SUB-ASSEMBLY RH

HINT:
Use the same procedure for the RH side as for the LH side.



9. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE
  1. for 2AD-FTV:
    Remove the engine with transaxle (Click here).

  1. for 2AD-FHV:
    Remove the engine with transaxle (Click here).



10. REMOVE NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY
  1. Remove the clamp and disconnect the steering column hole cover from the steering gear.



11. REMOVE STEERING INTERMEDIATE SHAFT


C132129E01
  1. Place matchmarks on the intermediate shaft of the steering gear.

  1. Remove the bolt and the steering intermediate shaft from the steering gear.



12. REMOVE STEERING GEAR ASSEMBLY


C128838
  1. Remove the 2 bolts, 2 nuts and steering gear from the front suspension crossmember.

    NOTICE:
    Keep the nut from rotating while turning the bolt.



13. SECURE STEERING GEAR ASSEMBLY


    C151611E02
  1. Using SST wrapped with protective tape, secure the steering gear in a vise.

    SST
    09612-00012  

    HINT:
    Remove and reinstall SST as needed.



14. REMOVE TIE ROD END SUB-ASSEMBLY LH


    F040050E19
  1. Put matchmarks on the tie rod end subassembly and rack end.

  1. Remove the tie rod end sub-assembly and lock nut.



15. REMOVE TIE ROD END SUB-ASSEMBLY RH

HINT:
Use the same procedure described for the No. 2 tie rod end sub-assembly.